COOLANT > ON-VEHICLE INSPECTION |
| 1. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD) |
![]() |
Remove the 8 bolts and under cover.
| 2. DRAIN ENGINE COOLANT |
![]() |
Remove the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug and the radiator drain cock plug and then drain the coolant.

| 3. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Tighten the cylinder block drain cock plug.
![]() |
Fill the radiator with TOYOTA Super Long Life Coolant (SLLC) to the reservoir tank's FULL line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the FULL line, add TOYOTA SLLC to the FULL line.
Install the radiator reservoir cap.
![]() |
Using a wrench, install the vent plug.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
After the coolant cools down, check that the coolant level is at the FULL line.
If the coolant level is below the low line, add TOYOTA SLLC to the FULL line.
| 4. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks (Click here).
| 5. INSTALL NO. 1 ENGINE UNDER COVER (for 4WD) |
![]() |
Install the under cover with the 8 bolts.