WATER PUMP (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD) |
Remove the 4 bolts and cover.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
![]() |
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug.

| 4. DISCONNECT RADIATOR HOSE INLET |
| 5. REMOVE FAN SHROUD |
![]() |
Remove the 3 bolts and oil reservoir.
Disconnect the No. 1 and No. 2 water by-pass hoses from the tank upper and lower.
Remove the 2 bolts and radiator reservoir.
Loosen the 4 nuts holding the fluid coupling fan.
Remove the drive belt .
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the water pump.
| 6. REMOVE COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System) |
![]() |
Disconnect the connector.
![]() |
Remove the 4 bolts and compressor.
| 7. REMOVE GENERATOR ASSEMBLY |
![]() |
Remove the nut and generator wire.
Disconnect the generator connector.
Remove the 2 bolts and generator.
| 8. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY |
![]() |
Remove the 4 bolts and belt tensioner.
| 9. REMOVE EGR COOLER WITH ELECTRIC EGR CONTROL VALVE AND NO. 2 EGR VALVE |
Remove the EGR cooler (Click here).
| 10. REMOVE NO. 4 INJECTION PIPE |
![]() |
Remove the bolt and disconnect the injection pipe clamp.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 11. REMOVE VENTILATION PIPE |
![]() |
Remove the bolt and ventilation pipe.
| 12. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Remove the 10 bolts, 2 nuts, cylinder head cover and gasket.
| 13. REMOVE NO. 1 TIMING BELT COVER |
![]() |
Remove the bolt and water hose clamp.
Remove the wire harness clamp.
Remove the 6 bolts and timing belt cover.
| 14. REMOVE TIMING BELT |
![]() |
Turn the crankshaft clockwise and align the timing marks as shown in the illustration.
![]() |
Uniformly loosen the 2 bolts and remove the timing belt tensioner.
Remove the timing belt.
Using a 10 mm hexagon wrench, remove the bolt, timing belt idler and washer.

| 15. REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY |
| 16. REMOVE CAMSHAFT TIMING PULLEY |
![]() |
Remove the bolt of the camshaft timing pulley by holding the camshaft with a wrench.
Remove the camshaft timing pulley.
| 17. REMOVE NO. 2 TIMING BELT COVER |
Remove the 4 bolts, nuts and timing belt cover.
| 18. REMOVE CYLINDER BLOCK INSULATOR |
![]() |
Remove the cylinder block insulator from the head.
| 19. REMOVE WATER PUMP ASSEMBLY |
![]() |
Remove the 2 nuts, 5 bolts, water pump and gasket.