Home › ENGINE ยท 1KD-FTV › COOLING › THERMOSTAT (w/ EGR Cooler)

THERMOSTAT (w/ EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug.


    A147246E01



4. REMOVE AIR CLEANER ASSEMBLY


A099628E02
  1. Disconnect the MAF meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. for Ventilation Hose Type:
    Disconnect the ventilation hose.

  1. Remove the 2 bolts and air cleaner.



5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A110362
  1. Remove the 3 bolts, 2 nuts and cover.



6. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR


    A149802
  1. Detach the 2 clamps.

  1. Disconnect the vacuum hose from the manifold absolute pressure sensor.

  1. Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.



    A135918
  1. Loosen the 2 clamps.



    A135919
  1. Remove the 4 bolts and intercooler.



7. REMOVE COMPRESSOR INLET ELBOW


    A110341
  1. for Ventilation Pipe Type:
    Remove the ventilation pipe.

    1. Move the clamp so that the hose can be disconnected.

    2. Remove the ventilation pipe.

  1. Disconnect the 2 connectors from the turbocharger.

  1. Remove the wire clamp's clip from the inlet elbow.

  1. Remove the 2 nuts, inlet elbow and gasket.



8. DISCONNECT RADIATOR HOSE INLET


9. DISCONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)


A097634E01
  1. Remove the bolt and disconnect the clamp.



10. REMOVE WATER INLET


A097637E01
  1. Remove the 3 bolts and water inlet.



11. REMOVE THERMOSTAT