Home › ENGINE ยท 2KD-FTV › COOLING › THERMOSTAT (w/ EGR Cooler)

THERMOSTAT (w/ EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)
  1. Remove the 8 bolts and under cover.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug.


    A147246E01



4. REMOVE AIR CLEANER ASSEMBLY
  1. for Ventilation Hose Type:
    Disconnect the ventilation hose.

  1. w/ Mass Air Flow Meter:
    Disconnect the mass air flow meter sensor connector.

  1. w/ Intake Air Temperature Sensor:
    Disconnect the intake air temperature sensor connector.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A135916
  1. Remove the 3 bolts, 2 nut and engine cover.



6. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR


    A149802
  1. Detach the 2 clamps.

  1. Disconnect the vacuum hose from the manifold absolute pressure sensor.

  1. Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.



    A135918
  1. Loosen the 2 clamps.



    A135919
  1. Remove the 4 bolts and intercooler.



7. REMOVE COMPRESSOR INLET ELBOW


  1. for Vacuum Controlled Actuator:



      A224456
    1. for Ventilation Pipe Type:
      Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.

    2. for Ventilation Pipe Type:
      Loosen the clamp, and then remove the compressor inlet elbow and air cleaner hose from the turbocharger.



  1. for Motor Controlled Actuator:



      A211832
    1. for Ventilation Pipe Type:
      Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.



    2. A211833
    3. Disconnect the 2 connectors from the turbocharger.

    4. Detach the wire harness clamp.

    5. Remove the 2 nuts, inlet elbow and gasket.



8. DISCONNECT RADIATOR HOSE INLET


9. REMOVE WATER INLET


A097637E01
  1. Remove the 3 bolts and water inlet.



10. REMOVE THERMOSTAT