Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REASSEMBLY

for Preparation Click here



1. INSTALL STUD BOLT



A208210E01

Torque:
for A and E:
5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
for B:
7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
for C:
15 N*m{ 153 kgf*cm , 11 ft.*lbf }
for D:
26 N*m{ 265 kgf*cm , 19 ft.*lbf }



2. INSTALL RING PIN



G036771E02



3. INSTALL STRAIGHT SCREW PLUG
  1. Apply an adhesive to the end of the screw plug.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



  1. Using a 6 mm hexagon wrench, install the screw plug.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



    A060223E01



4. INSTALL SEMICIRCULAR PLUG
  1. Remove any old packing (FIPG) material.

  1. Apply seal packing to the oil seal retainer as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    NOTICE:
    1. The semicircular plug must be installed within 3 minute from the completion of applying the seal packing.
    2. Prevent FIPG from being stuck to the camshaft thrust groove.



  1. Install the semicircular plug to the cylinder head.


    A061555E01



5. INSTALL INTAKE VALVE


A058114E01
  1. Install the valve, spring seat, compression spring and spring retainer.

  1. Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.

    SST
    09202-70020   (09202-00020)



    A060277E01
  1. Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

    NOTICE:
    Be careful not do damage the valve stem tip.



6. INSTALL EXHAUST VALVE


A058113E01
  1. Install the valve, spring seat, compression spring and spring retainer.

  1. Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.

    SST
    09202-70020   (09202-00020)



    A059917E01
  1. Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.



7. INSTALL VALVE LIFTER
  1. Install the valve lifter.

  1. Check that the valve lifter rotates smoothly by hand.