ENGINE UNIT > REPLACEMENT |
| 1. REMOVE TIMING GEAR COVER OIL SEAL |
![]() |
If the timing gear cover is removed from the cylinder block:
Using a screwdriver and hammer, tap out the oil seal.
![]() |
If the timing gear cover is installed to the cylinder block:
Using a knife, cut through the oil seal lip.
Using a screwdriver, pry out the oil seal.
| 2. REMOVE TIMING GEAR COVER OIL SEAL |
![]() |
If the timing gear cover is removed from the cylinder block.
Using a screwdriver and hammer, tap out the oil seal.
![]() |
If the timing gear cover is installed to the cylinder block.
Using SST, remove the oil seal.
| 3. REMOVE REAR ENGINE OIL SEAL |
![]() |
Using a screwdriver and hammer, tap out the oil seal.
| 4. INSTALL REAR ENGINE OIL SEAL |
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
Apply MP grease to the oil seal lip.
| 5. INSTALL TIMING GEAR COVER OIL SEAL |
![]() |
If the timing gear cover is removed from the cylinder block:
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
Apply MP grease to the oil seal lip.
![]() |
If the timing gear cover is installed to the cylinder block:
Apply MP grease to the oil seal lip.
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
| 6. INSTALL TIMING GEAR COVER OIL SEAL |
![]() |
If the timing gear cover is removed from the cylinder block:
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
Apply MP grease to the oil seal lip.
![]() |
If the timing gear cover is installed to the cylinder block:
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.