Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > REPLACEMENT

for Preparation Click here



1. REMOVE TIMING GEAR COVER OIL SEAL


A058117E01

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using a screwdriver and hammer, tap out the oil seal.



    A058126E01
  1. If the timing gear cover is installed to the cylinder block:

    1. Using a knife, cut through the oil seal lip.

    2. Using a screwdriver, pry out the oil seal.

      NOTICE:
      Be careful not to damage the crankshaft.



2. REMOVE TIMING GEAR COVER OIL SEAL


A058121E01

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using a screwdriver and hammer, tap out the oil seal.



    A058124E01
  1. If the timing gear cover is installed to the cylinder block:

    1. Using SST, remove the oil seal.

      SST
      09308-10010  
      09950-40011   (09957-04010)
      09950-60010   (09951-00350)



3. REMOVE REAR ENGINE OIL SEAL


A061819E01
  1. Using a screwdriver and hammer, tap out the oil seal.



4. INSTALL REAR ENGINE OIL SEAL


A061820E01
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the oil seal lip.



5. INSTALL TIMING GEAR COVER OIL SEAL


A058118E02

HINT:
There are 2 methods to install the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)

    2. Apply MP grease to the oil seal lip.



    A058127E01
  1. If the timing gear cover is installed to the cylinder block:

    1. Apply MP grease to the oil seal lip.

    2. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)



6. INSTALL TIMING GEAR COVER OIL SEAL


A058119E01

HINT:
There are 2 methods to install the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  

    2. Apply MP grease to the oil seal lip.



    A058125E01
  1. If the timing gear cover is installed to the cylinder block:

    1. Apply MP grease to a new oil seal lip.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011