INTEGRATION RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT INTEGRATION NO.1 RELAY |
![]() |
Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
![]() |
Measure the voltage of the EDU relay.
| Tester Connection | Condition | Specified Condition |
| 1J-8 - Body ground | Ignition switch ON | 10 to 14 V |
![]() |
Measure the voltage of the MAIN relay.
| Tester Connection | Condition | Specified Condition |
| 1J-4 - Body ground | Ignition switch ON | 10 to 14 V |