Home › ENGINE ยท 2KD-FTV › INTAKE › INTAKE AIR CONTROL SYSTEM (w/ EGR Cooler)

INTAKE AIR CONTROL SYSTEM (w/ EGR Cooler) > SYSTEM DIAGRAM

for Preparation Click here



INTAKE AIR CONTROL SYSTEM ILLUSTRATION
The swirl control valve is mounted on the intake manifold. The Vacuum Switching Valve (VSV) for swirl control valve changes the vacuum to actuate the actuator.
First, the ECM determines the opening angle of the swirl control valve. Then it uses the swirl control valve VSV to change the vacuum applied to the actuator's diaphragm to open and close the swirl control valve.

A224577E01


A224576E01


INTAKE AIR CONTROL SYSTEM WIRING DIAGRAM

A220713E02


A220714E02


TURBOCHARGER SYSTEM ILLUSTRATION (for Motor Controlled Actuator)
  1. The turbocharger system is comprised of the Variable Nozzle (VN) type turbocharger, turbo motor driver and ECM.
  2. The turbocharger has a nozzle vane which opens and closes to control the volume of the exhaust gas flowing into the turbine. This, in turn, controls the boost pressure. When the nozzle vane moves towards the closing direction, the pressure increases. When the vane moves towards the opening direction, the pressure decreases.
  3. The turbocharger actuator built on the compressor housing side activates the nozzle vane. The nozzle vane position sensor built on the actuator detects the opening angle of the nozzle vane. The turbo motor driver receives an opening angle request from the ECM and a nozzle vane position sensor signal. Based on these signals, the turbo motor driver operates the DC motor and controls the turbocharger's opening angle. The turbo motor driver sends the status as a turbo driver status signal to the ECM.
  4. The ECM sends a target nozzle vane position signal to the turbo motor driver to obtain the nozzle vane position for optimal pressure in accordance with the driving conditions.

A224576E02


TURBOCHARGER SYSTEM WIRING DIAGRAM (for Motor Controlled Actuator)

A220715E02