GLOW RELAY > ON-VEHICLE INSPECTION |
| 1. REMOVE GLOW RELAY (Marking: GLOW) |
Remove the engine room relay block cover.
Remove the glow relay from the engine room relay block.
| 2. INSPECT GLOW RELAY |
![]() |
Measure the resistance of the glow relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
| 3. INSTALL GLOW RELAY |