Home › ENGINE · 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler)

INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler) > INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR TEMPERATURE SENSOR



A108624E02

  1. Measure the resistance between the terminals.

    Standard resistance:
    2.21 k to 2.65 kΩ at 20°C (68°F)

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the ECT sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.