Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler)

INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE COVER SUB-ASSEMBLY


    A135916
  1. Remove the 3 bolts, 2 nuts and cover.



3. REMOVE INTAKE AIR TEMPERATURE SENSOR


    A135914
  1. Disconnect the IAT sensor connector.

  1. Using a 22 mm deep socket wrench, remove the IAT sensor.

    HINT:
    Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the intercooler is replaced.