INTERCOOLER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts, 2 nut and engine cover.
| 3. REMOVE INTAKE AIR TEMPERATURE SENSOR |
![]() |
Disconnect the IAT sensor connector.
Using a 22 mm deep socket wrench, remove the IAT sensor.
| 4. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR |
![]() |
Detach the 2 clamps and disconnect the sensor connector.
Remove the 2 bolts and sensor.
| 5. REMOVE INTERCOOLER ASSEMBLY |
![]() |
Loosen the 2 hose clamps of the No. 1 air hose.
![]() |
Loosen the 2 hose clamps of the No. 2 air hose.
![]() |
Remove the 4 bolts and intercooler.
![]() |
Remove the 4 bolts, intake air connector and gasket.