Home › ENGINE · 2KD-FTV › EMISSION CONTROL › VACUUM REGULATING VALVE (w/ EGR System with EGR Cooler)

VACUUM REGULATING VALVE (w/ EGR System with EGR Cooler) > INSPECTION

for Preparation Click here


NOTICE:
Do not remove the electric vacuum regulating valve.



1. INSPECT ELECTRIC VACUUM REGULATING VALVE


    A151146E01
  1. Measure the resistance of the electric vacuum regulating valve (E-VRV).

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    11 to 13 Ω at 20°C (68°F)
    1 - Body Ground
    2 - Body Ground
    10 MΩ or higher

    If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.



    A151813E02
  1. Check operation of the E-VRV.

    1. When a vacuum of 66.7 kPa (500mmHg, 19.7 in.Hg) is applied to the port E, check that air flows from port F to the filter.
      If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.



    2. A151148E01
    3. Apply battery voltage across terminals 1 and 2.

    4. Check that air flows from port F to port E.
      If the result is not as specified, replace the electric EGR control valve assembly with E-VRV.