Home › ENGINE ยท 5L-E › STARTING › GLOW PLUG

GLOW PLUG > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INTAKE PIPE ASSEMBLY


    A118426
  1. Loosen the 2 intake pipe clamps.

  1. Remove the 2 bolts and intake pipe.



3. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.



4. REMOVE GLOW PLUG ASSEMBLY


    A118420
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.