ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE) > L4 Position Switch Circuit |

| 1.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH) |
![]() |
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM AND BODY GROUND) |
![]() |
Disconnect the T4 switch connector.
Disconnect the E17 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E17-13 (L4) - T4-1 (L4) | Below 1 Ω |
| T4-2 (L4) - Body ground | Below 1 Ω |
| E17-13 (L4) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||