AUTOMATIC TRANSMISSION SYSTEM > L4 Position Switch Circuit |

| 1.CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() |
Disconnect the T4 switch connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| T4-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH) |
![]() |
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM) |
![]() |
Disconnect the T4 switch connector.
Disconnect the E9 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| E9-11 (L4) - T4-1 | Always | Below 1 Ω |
| E9-11 (L4) or T4-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||