Home › TRANSMISSION · A343F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > A/T P Indicator Circuit

for Preparation Click here


DESCRIPTION

The propeller shaft and wheels are free even when the transmission shift lever is on P, as long as the transfer shift lever is on N. The A/T P indicator illuminates to warn the driver that the propeller shaft and wheels are not locked.
If the A/T P indicator illuminates, the transfer shift lever should be moved from N.

WIRING DIAGRAM


C175018E05


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)


    C155111E05
  1. Disconnect the T5 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
A110992E12
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH
OK


3.CHECK WIRE HARNESS (NO. 2 TRANSFER INDICATOR SWITCH - ECM)


    C175140E02
  1. Disconnect the T5 switch connector.

  1. Disconnect the E9 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-23 (TFN) - T5-1
    Always
    Below 1 Ω
    E9-23 (TFN) or T5-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM