DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | Conditions (a), (b) and (c) continue for 8 seconds or more: (2 trip detection logic) (a) Engine coolant temperature is more than 70°C (158°F) (b) Engine speed is between 1,500 rpm and 4,000 rpm (c) No speed signal is input to ECM |
|
| Conditions (a), (b) and (c) continue for 5 seconds or more: (2 trip detection logic) (a) Vehicle running (b) Under fuel-cut operation (c) No speed signal is input to ECM |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle.
Check the speedometer reading in the combination meter.
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Vehicle Speed.
Check the vehicle speed at an engine speed of 2,000 rpm or more while the vehicle is running.
|
| ||||
| NG | |
| 3.CHECK ECM TERMINAL VOLTAGE (SPD TERMINAL) |
![]() |
While idling the engine, check the waveform of the ECM connectors using an oscilloscope.
Jack up the vehicle.
Move the shift lever to the N position.
Turn the ignition switch ON.
Check the waveform between the specified terminals of the ECM connectors as the rear wheels are turned slowly.
| Tester Connection | Specified Condition |
| SPD (E6-17) - E1 (E7-7) | Generated intermittently |
|
| ||||
| OK | ||
| ||