Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (w/ EGR Cooler)

DTC    P0606    ECM / PCM Processor

DTC    P0607    Control Module Performance

DTC    P1611    IC Circuit Malfunction

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
P0606
P0607
P1611
ECM internal error
(1 trip detection logic)
ECM

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0606, P0607 AND/OR P1611)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Enter the following menu: Powertrain / Engine / DTC.

  1. Read DTCs.

    Display (DTC Output)
    Proceed to
    P0606 or P0607 or P1611
    A
    P0606 or P0607 or P1611 and other DTCs
    B



B
GO TO DTC CHART (Click here)
A

REPLACE ECM (Click here)