DTC P0105 Manifold Absolute Pressure / Barometric Pressure Circuit |
DTC P0107 Manifold Absolute Pressure / Barometric Pressure Circuit Low Input |
DTC P0108 Manifold Absolute Pressure / Barometric Pressure Circuit High Input |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0105 P0107 P0108 | Open or short in manifold absolute pressure sensor circuit for 0.8 seconds or more (1 trip detection logic) |
|
| Intake Manifold Pressure | Malfunction |
| Approximately 0 kPa | Short in PIM circuit |
| 250 kPa (1,875 mmHg, 73.8 in.Hg) or more |
|

| 1.READ VALUE USING INTELLIGENT TESTER (MAP) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / MAP.
Read the value.
|
| ||||
| NG | |
| 2.CHECK ECM (VC VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| VC (E8-18) - E2 (E8-28) | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 3.INSPECT ECM (PIM VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connectors.
| Tester Connection | Condition | Specified Condition |
| PIM (E7-28) - E2 (E8-28) | Applied negative pressure of 40 kPa (300 mmHg, 11.8 in.Hg) | 0.1 to 0.7 V |
| PIM (E7-28) - E2 (E8-28) | Same as atmospheric pressure | 0.8 to 1.5 V |
| PIM (E7-28) - E2 (E8-28) | Applied positive pressure of 170 kPa (1,275 mmHg, 50.2 in.Hg) | 1.6 to 2.3 V |
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (MANIFOLD ABSOLUTE PRESSURE SENSOR - ECM) |
![]() |
Disconnect the T9 manifold absolute pressure sensor connector.
Disconnect the E7 and E8 ECM connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| PIM (T9-2) - PIM (E7-28) | Below 1 Ω |
| VC (T9-3) - VC (E8-18) | Below 1 Ω |
| E (T9-1) - E2 (E8-28) | Below 1 Ω |
| Tester Connection | Specified Condition |
| PIM (T9-2) or PIM (E7-28) - Body ground | 10 kΩ or higher |
| VC (T9-3) or VC (E8-18) - Body ground | 10 kΩ or higher |
| E (T9-1) or E2 (E8-28) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT TURBOCHARGER SUB-ASSEMBLY |
Check the turbocharger sub-assembly (Click here).
|
| ||||
| OK | |
| 6.INSPECT EGR VALVE ASSEMBLY |
Check the EGR valve assembly (Click here).
|
| ||||
| OK | ||
| ||