GENERATOR (for DENSO Made) > INSPECTION |
| 1. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the rotor for an open circuit.
Measure the resistance between the slip rings.
![]() |
Check if the rotor is grounded.
Measure the resistance between each slip ring and the rotor.
Check that the slip rings are not rough or scored.
If rough or scored, replace the rotor assembly.
![]() |
Using a vernier caliper, measure the diameter of each slip ring.
| 2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the exposed brush length.
| 3. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the bearing is not rough or worn, and that it rotates smoothly.
If necessary, replace the generator drive end frame bearing.
| 4. INSPECT GENERATOR ROTOR BEARING |
![]() |
Check that the bearing is not rough or worn, and that it rotates smoothly.
If necessary, replace the generator rotor assembly.
| 5. INSPECT GENERATOR PULLEY WITH CLUTCH |
When rotating the pulley, check that it turns clockwise and that it does not turn counterclockwise.
If the result is not as specified, replace the generator pulley with clutch.