Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR (for DENSO Made)

GENERATOR (for DENSO Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY CAP
  1. Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.



2. REMOVE GENERATOR PULLEY WITH CLUTCH


A203706E01
  1. Mount the generator in a vise between aluminum plates.

  1. Install SST (A) and (B) to the generator pulley as shown in the illustration.

    SST
    09820-63021  



    A203707E02
  1. Using a wrench to hold SST (A), turn SST (B) counterclockwise to loosen the generator pulley.

  1. Remove the generator pulley.



3. REMOVE GENERATOR REAR END COVER


    A122140
  1. Remove the 3 nuts and end cover.



    A196077
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A196078
  1. Remove the 2 screws and brush holder.



5. REMOVE GENERATOR COIL ASSEMBLY


    A196079
  1. Remove the 4 bolts.



    A122144E01
  1. Using SST, remove the coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the generator washer.



6. REMOVE GENERATOR ROTOR ASSEMBLY