STARTER (for 2.0 kW Type) > REASSEMBLY |
| 1. INSTALL STARTER CLUTCH SUB-ASSEMBLY |
Apply high-temperature grease to the idler gear, pinion gear, steel ball, return spring, clutch roller and retainer.
![]() |
Install the steel ball.
Insert the return spring into the starter clutch hole.
Install the starter clutch, pinion gear, idler gear, retainer and clutch roller to the starter drive housing.

![]() |
Install the starter drive housing to the magnet starter switch with the 2 screws.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
Install the starter armature to the starter yoke.
| 3. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
Install a new O-ring to the groove of the starter yoke.
Install the starter brush holder to the starter yoke.
Install the 4 starter brushes to the starter brush holder.
![]() |
Using a screwdriver, pull back the spring.
Install the brush to the brush holder.
![]() |
Install the commutator end frame with the 2 screws.
| 4. INSTALL STARTER YOKE ASSEMBLY |
Install a new O-ring to the groove of the starter yoke.
![]() |
Align the protrusion of the starter yoke with the groove of the magnet starter switch.
![]() |
Install the starter yoke with the 2 through bolts.
Connect the lead wire to terminal C with the nut.