DTC P0717/67 Input Speed Sensor Circuit No Signal |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0717/67 |
|
|

| 1.CHECK SPEED SENSOR (NC0) (INSTALLATION) |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NC0) |
![]() |
Disconnect the T6 sensor connector from the transmission.
![]() |
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
![]() |
| Item | Content |
| Tester Connection | E11-34 (NC0+) - E11-26 (NC0-) |
| Tool Setting | 5 V/DIV, 0.5 msec./DIV. |
| Condition | Engine is idling (P or N position) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SPEED SENSOR (NC0) - ECM) |
![]() |
Disconnect the E11 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E11-34 (NC0+) - E11-26 (NC0-) | 20°C (68°F) | 560 to 680 Ω |
| E11-34 (NC0+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| E11-26 (NC0-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||