DTC P0717 Turbine Speed Sensor Circuit No Signal |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0717 | All the conditions below are detected for 5 sec. or more (1 trip detection logic). (a) Gear change is not performed. (b) The gear position is 4th or 5th. (c) The T/M input shaft rpm is 300 rpm or less. (d) The T/M output shaft rpm is 1000 rpm or more. (e) The park/neutral position switch:
|
|

| 1.CHECK SPEED SENSOR (INSTALLATION) |
![]() |
Check the speed sensor NT installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NT) |
![]() |
Disconnect the T6 speed sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR (NT) - TCM) |
![]() |
Disconnect the T19 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T19-3 (NT+) - T19-2 (NT-) | 20°C (68°F) | 560 to 680 Ω |
| T19-3 (NT+) - Body ground | Always | 10 kΩ or higher |
| T19-2 (NT-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||