DTC P2121 Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2121 | Condition (a) continues for 2 seconds: (a) Difference between VPA1 and VPA2 exceeds the threshold (1 trip detection logic) |
|
| 1.READ VALUE USING INTELLIGENT TESTER (ACCEL SENS. NO.1 VOLT % AND ACCEL SENS. NO.2 VOLT %) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List /Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.
Read the values.
| Accelerator Pedal | Accel Sens. No.1 Volt % | Accel Sens. No.2 Volt % |
| Released | 8 to 28% | 30 to 55% |
| Depressed | 51 to 71% | 73 to 98% |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (ACCELERATOR PEDAL POSITION SENSOR - ECM) |
![]() |
Disconnect the A13 sensor connector.
Disconnect the E5 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| VCP2 (A13-1) - VCP2 (E5-27) | Below 1 Ω |
| EPA2 (A13-2) - EPA2 (E5-29) | Below 1 Ω |
| VPA2 (A13-3) - VPA2 (E5-23) | Below 1 Ω |
| VCPA (A13-4) - VCPA (E5-26) | Below 1 Ω |
| EPA (A13-5) - EPA (E5-28) | Below 1 Ω |
| VPA (A13-6) - VPA (E5-22) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VCP2 (A13-1) or VCP2 (E5-27) - Body ground | 10 kΩ or higher |
| EPA2 (A13-2) or EPA2 (E5-29) - Body ground | 10 kΩ or higher |
| VPA2 (A13-3) or VPA2 (E5-23) - Body ground | 10 kΩ or higher |
| VCPA (A13-4) or VCPA (E5-26) - Body ground | 10 kΩ or higher |
| EPA (A13-5) or EPA (E5-28) - Body ground | 10 kΩ or higher |
| VPA (A13-6) or VPA (E5-22) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE ACCELERATOR PEDAL ROD ASSEMBLY |
Replace the accelerator pedal rod assembly (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P2121) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear DTCs (Click here).
Start the engine.
Allow the engine to idle for 15 seconds.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P2121 | A |
| No output | B |
|
| ||||
| A | ||
| ||