Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    23    Pressure Switch Circuit

for Preparation Click here


DESCRIPTION


E113418E12

The pressure switch turns off when the A/C refrigerant pressure drops too low or rises too high. When the air conditioning amplifier detects the off state of the pressure switch, the amplifier outputs signals to the magnet clutch relay to turn the magnet clutch OFF

DTC Code
Detection Item
Trouble Area
23
When either condition below is met:
  1. Open in pressure switch circuit
  2. Abnormal refrigerant pressure:
Below 196 kPa (2.0 kgf/cm2, 28 psi)
Over 3140 kPa (32.0 kgf/cm2, 455 psi)
  1. Pressure switch
  2. Harness or connector
  3. Refrigerant pipe line
  4. Air conditioning amplifier assembly

WIRING DIAGRAM


E171028E01


INSPECTION PROCEDURE

1.CHECK REFRIGERANT PRESSURE
  1. Install a manifold gauge.

  1. Read the manifold gauge pressure when these conditions are met.
    Test conditions:

    1. RECIRCULATION switch ON and temperature at air inlet is 30 to 35°C (86 to 95°F)
    2. Engine running at 1500 rpm
    3. Blower speed control switch in HI position
    4. Temperature control switch in COOL position
    5. Air conditioning switch ON
    6. Doors fully opened

    Standard pressure:
    Pressure on high-pressure side
    1.37 to 1.57 MPa (13.9 to 16.0 kgf/cm2, 198 to 228 psi)

    HINT:
    If the refrigerant pressure is below 196 kPa (2.0 kgf/cm2, 28 psi), the refrigerant amount in the air conditioning cycle may have decreased significantly due to gas leakage or other problems.



NG
CHECK REFRIGERANT
OK


2.CHECK AIR CONDITIONING OPERATION


    E170953E02
  1. Disconnect the P1 switch connector.

  1. Using a service wire, connect terminals 1 and 2 of the connector on the vehicle wire harness side.

  1. Start the engine.

  1. Turn the air conditioning switch ON and check the magnet clutch.

    OK:
    With terminals 1 and 2 connected, magnet clutch is ON.
    With terminals 1 and 2 disconnected, magnet clutch is OFF.



NG
Go to step 3
OK

REPLACE PRESSURE SWITCH 

3.CHECK HARNESS AND CONNECTOR (PRESSURE SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND)


    E170954E03
  1. Disconnect the P1 switch connector.

  1. Disconnect the A38 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A38-5 (PSW) - P1-2
    Always
    Below 1 Ω
    P1-1 - Body ground
    A38-5 (PSW) - Body ground
    Always
    10 kΩ or higher
    P1-2 - Body ground

    Result 
    Result
    Proceed to
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    A
    OK (Checking from the DTC)
    B
    NG
    C



B
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)