GENERATOR (for DENSO Made) > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY |
Mount the generator in a vise between aluminum plates.
![]() |
Install SST 1-A to the pulley shaft.
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Install SST 1-B to SST 1-A.
Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.
![]() |
Insert SST 2 and attach it to the pulley nut.
![]() |
To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
Remove SST 2 from the generator.
![]() |
Turn SST 1-B in the direction shown in the illustration and remove SST 1-A and B.
Remove the pulley nut and pulley.
| 2. REMOVE GENERATOR REAR END COVER |
![]() |
Remove the nut and terminal insulator.
Remove the bolt, 3 nuts, plate terminal and end cover.
| 3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the brush holder cover from the brush holder.
Remove the 2 screws and brush holder.
| 4. REMOVE GENERATOR REGULATOR ASSEMBLY |
Remove the 3 screws and generator regulator.
| 5. REMOVE GENERATOR HOLDER WITH RECTIFIER |
![]() |
Remove the 3 screws and holder with rectifier.
| 6. REMOVE GENERATOR RECTIFIER END FRAME |
![]() |
Remove the 3 rubber insulators.
Remove the seal plate.
Remove the 4 nuts.
![]() |
Using SST, remove the rectifier end frame.
| 7. REMOVE GENERATOR ROTOR ASSEMBLY |
Remove the generator washer from the rotor.
Remove the rotor from the drive end frame.