GENERATOR (for DENSO Made) > REASSEMBLY |
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
Install the generator rotor.
Install the generator washer onto the rotor.
| 2. INSTALL GENERATOR RECTIFIER END FRAME |
![]() |
Using a 19 mm socket wrench and press, slowly press in the rectifier end frame.
Install the 4 nuts.
Install the seal plate onto the rectifier end frame.
![]() |
Install the 3 rubber insulators onto the lead wires.
| 3. INSTALL GENERATOR HOLDER WITH RECTIFIER |
Install the rectifier holder while pushing it with the 3 screws.
| 4. INSTALL GENERATOR REGULATOR ASSEMBLY |
Install the 3 screws and generator regulator.
| 5. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Install the brush holder with the 2 screws.
Install the brush holder cover.
| 6. INSTALL GENERATOR REAR END COVER |
![]() |
Install the end cover and plate terminal with the bolt and 3 nuts.
Install the terminal insulator with the nut.
| 7. INSTALL GENERATOR PULLEY |
Temporarily install the generator pulley by hand.
Mount the generator in a vise between aluminum plates.
![]() |
Install SST 1-A to the pulley shaft.
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Install SST 1-B to SST 1-A.
Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.
![]() |
Insert SST 2 and attach it to the pulley nut.
![]() |
Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.
Remove SST 2 from the generator.
![]() |
Turn SST 1-B in the direction shown in the illustration and remove SST 1-A and B.
Turn the generator pulley and check that the generator pulley moves smoothly.