Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > VC Output Circuit

for Preparation Click here


DESCRIPTION

The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, canister pump module, etc.

WIRING DIAGRAM


A116411E08


INSPECTION PROCEDURE

1.CHECK MIL
  1. Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch ON.

OK:
MIL lights up



OK
SYSTEM OK
NG


2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Check the connection between the intelligent tester and ECM.

Result:
Condition
Proceed to
Communication is possible
A
Communication is not possible
B



A
GO TO MIL CIRCUIT
B


3.INSPECT ECM (VC VOLTAGE)
A119979E34
  1. Turn the ignition switch ON.

  1. Measure the voltage of the ECM connector.

Standard voltage:
Tester Connection
Specified Condition
E12-18 (VC) - E12-3 (E1)
Voltage is not 5 V


NEXT


4.CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the T25 throttle body connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL illuminates
A
MIL does not illuminate
B



A
REPLACE THROTTLE BODY
B


5.CHECK WIRE HARNESS (ECM - BODY GROUND)
G034690E08
  1. Disconnect the T25 throttle body connector.

  1. Disconnect the E12 ECM connector.

  1. Measure the resistance of the wire harness side connector.

Standard resistance:
Tester Connection
Specified Condition
E12-18 (VC) - Body ground
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM