Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY



E171665E02

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    10 (AU1) - 8 (EAU)
    VOL+ switch is pushed
    1000 Ω
    10 (AU1) - 8 (EAU)
    VOL- switch is pushed
    3110 Ω
    10 (AU1) - 8 (EAU)
    No switch is pushed
    100 kΩ or higher
    10 (AU1) - 8 (EAU)
    SEEK+ switch is pushed
    Below 2.5 Ω
    10 (AU1) - 8 (EAU)
    SEEK- switch is pushed
    329 Ω
    9 (AU2) - 8 (EAU)
    MODE switch is pushed
    Below 2.5 Ω
    9 (AU2) - 8 (EAU)
    No switch is pushed
    100 kΩ or higher

    If the result is not as specified, replace the switch assembly.