Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › SOLAR SENSOR (for Automatic Air Conditioning System)

SOLAR SENSOR (for Automatic Air Conditioning System) > INSPECTION

for Preparation Click here



1. INSPECT SOLAR SENSOR


E170951E03
  1. Measure the resistance according to the value(s) in the table below.

    NOTICE:
    Connect the ohmmeter's negative (-) lead to terminal 1 and positive (+) lead to terminal 2.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Sensor is subjected to electric light
    Below 10 kΩ
    Sensor is covered with a cloth
    10 kΩ or higher

    NOTICE:
    The connection procedure for a digital tester, such as a TOYOTA electrical tester, is shown above. When using an analog tester, connect the negative (-) lead to terminal 2 and the positive (+) lead to terminal 1.

    HINT:
    1. As the inspection light is moved away from the sensor, the resistance increases.
    2. Use an incandescent light for inspection. Bring it within 30 cm (11.8 in.) of the A/C solar sensor.
      If the result is not as specified, replace the solar sensor.