Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > ADJUSTMENT

for Preparation Click here



1. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT
  1. Prepare the vehicle:

    1. Ensure that the vehicle has no damage or deformation around the fog lights.
    2. Fill the fuel tank.
    3. Make sure that the oil is filled to the specified level.
    4. Make sure that the coolant is filled to the specified level.
    5. Inflate the tires to the appropriate pressure.
    6. Unload the trunk and vehicle, ensuring that the spare tire, tools, and jack are in their original positions.
    7. Have a person of average weight (55 kg, 121 lb) sit in the driver seat.



2. PREPARATION FOR FOG LIGHT AIMING (Using a screen)
  1. Prepare the vehicle according to the following conditions:

    1. Move the vehicle to a location that is sufficiently dark so that the headlight cutoff line can be visually checked. The cutoff line is an imaginary plane below which headlight light is projected and above which light is not projected.
    2. Move the vehicle to a level surface.
    3. Point the front of the vehicle at a wall. The wall must be perpendicular to the surface that the vehicle is on.
    4. Position the vehicle 10 m (32.8 ft.) from the wall.
    5. Push down on the vehicle several times to settle the suspension.

      HINT:
      A distance of 10 m (32.8 ft.) between the vehicle and the wall is necessary for proper aim adjustment. If unavailable, secure a distance of exactly 3 m (9.8 ft.). View the part of the illustration below applicable to the distance from the vehicle to the wall.

  1. Prepare a piece of thick white paper that is approximately 2 m (6.6 ft.) (height) x 4 m (13.1 ft.) (width) to use as a screen.

  1. Draw a vertical line down the center of the screen (V line).

  1. Set the screen as shown in the illustration.

    HINT:
    1. Stand the screen perpendicular to the ground.

    2. Align the V line on the screen with the center of the vehicle.


      E171148E01



    B117616E01
  1. Draw base lines (H line, V LH and V RH lines) on the screen as shown in the illustration.

    HINT:
    Mark the fog light bulb center marks on the screen. If the center mark cannot be observed on the fog light, use the center of the fog light bulb or the manufacturer's name marked on the fog light as the center mark.


    1. H Line (fog light height): Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.

    2. V LH Line, V RH Line (center mark position of LH and RH fog lights): Draw two vertical lines so that they intersect the H line at each center mark.



3. INSPECT FOG LIGHT AIMING
  1. Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.

    NOTICE:
    Do not keep the fog light covered for more than 3 minutes. The fog light lens is made of synthetic resin, which may melt or be damaged due to excessive heat.

  1. Start the engine.



  1. Turn on the fog lights and make sure that the cutoff line is within the specified area shown in the illustration.


    B117629E02



4. ADJUST FOG LIGHT AIMING


E171149E01
  1. Adjust the fog light aim into the specified range by turning the aiming screw with a screwdriver.

    NOTICE:
    If the screw is tightened too much, loosen it and then retighten it so that the final turn of the screw is in the clockwise direction.