Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY


B118558E01
  1. Attach the 4 claws to install the steering pad switch.

  1. Install the 2 screws.

  1. Connect all connectors.



2. INSTALL STEERING PAD ASSEMBLY


B085363E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the airbag connector.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Using a T30 "torx" socket, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



3. INSTALL NO. 2 STEERING WHEEL COVER LOWER


4. INSTALL NO. 3 STEERING WHEEL COVER LOWER


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).