Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 3 STEERING WHEEL COVER LOWER


3. REMOVE NO. 2 STEERING WHEEL COVER LOWER


4. REMOVE STEERING PAD ASSEMBLY


B112129E01
  1. Straighten the front wheels.

  1. Using a T30 "torx" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.



    B085362E03
  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the airbag connector.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



5. REMOVE STEERING PAD SWITCH ASSEMBLY


B118558E01
  1. Disconnect all connectors.

  1. Remove the screws.

  1. Detach the 4 claws and remove the steering pad switch.