Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Horn Circuit


DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the ECU turns on the HORN relay, causing the vehicle horn to sound at 0.4 seconds intervals.

WIRING DIAGRAM


B119743E02


INSPECTION PROCEDURE

1.CHECK HORN ASSEMBLY
  1. Press the horn switch and check if the horn sounds.
    Result: 
    Result
    Proceed to
    Horn sounds
    A
    Horn does not sound
    B



B
GO TO HORN SYSTEM
A


2.CHECK WIRE HARNESS (THEFT WARNING ECU - INTEGRATION RELAY (HORN RELAY) AND BODY GROUND)
B119774E01
  1. Disconnect the T16 ECU connector.

  1. Disconnect the 1I integration relay connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T16-24 (HORN) - 1I-7
    Below 1 Ω
    T16-24 (HORN) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY