THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.INSPECT SECURITY INDICATOR LIGHT ASSEMBLY |
![]() |
Remove the security indicator light.
Apply battery voltage between the terminals of the indicator, and check the illumination of the security indicator.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Illuminates |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SECURITY INDICATOR LIGHT - THEFT WARNING ECU AND BODY GROUND) |
![]() |
Disconnect the S10 indicator connector.
Disconnect the T16 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T16-22 (IND) - S10-2 (LP) | Below 1 Ω |
| T16-22 (IND) or S10-2 (LP) - Body ground | 10 kΩ or higher |
| S10-1 (E) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||