THEFT DETERRENT SYSTEM > Driver Side Door Courtesy Switch Circuit |

| 1.CHECK COMBINATION METER ASSEMBLY |
When the driver side door is opened / closed, check that the indicator in the combination meter operates normally.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (COMBINATION METER - THEFT WARNING ECU) |
![]() |
Disconnect the C8 meter connector.
Disconnect the T16 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-17 - T16-7 (CTY) | Below 1 Ω |
Measure the voltage of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-17 - Body ground | 10 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR DRIVER SIDE) |
![]() |
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH (FOR DRIVER SIDE)) |
![]() |
Disconnect the C8 meter connector.
Disconnect the D2 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-16 - D2-1 | Below 1 Ω |
|
| ||||
| OK | ||
| ||