Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Rear Door Courtesy Switch LH Circuit


DESCRIPTION

The Theft warning ECU detects the condition of the rear door courtesy light switch rear LH.

WIRING DIAGRAM


B115391E02


INSPECTION PROCEDURE

1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR REAR LH)
B119755E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
OK


2.CHECK WIRE HARNESS (REAR DOOR COURTESY LIGHT SWITCH (FOR REAR LH) - THEFT WARNING ECU)
B115392E02
  1. Disconnect the D4 switch connector.

  1. Disconnect the T16 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D4-1 - T16-7 (CTY)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE