THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.INSPECT SECURITY COURTESY SWITCH (ENGINE HOOD COURTESY SWITCH) |
![]() |
Remove the courtesy switch from the hood lock.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed (ON) | Below 1 Ω |
| 1 - 2 | Pushed (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SECURITY COURTESY SWITCH - THEFT WARNING ECU AND BODY GROUND) |
![]() |
Disconnect the E3 switch connector.
Disconnect the T16 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E3-1 - T16-9 (DSWH) | Below 1 Ω |
| E3-1 or T16-9 (DSWH) - Body ground | 10 kΩ or higher |
| E3-2 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||