Home › ENGINE ยท 5L-E › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY
  1. Temporally install the pipe support and clamp with the bolt.

  1. Install a new gasket to the exhaust manifold.

  1. Install the front exhaust pipe to the exhaust manifold with the 3 nuts. Alternately tighten the bolts in several passes.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }

  1. Install the stay to the transmission with the 2 bolts.

    Torque:
    71 N*m{ 724 kgf*cm , 52 ft.*lbf }

  1. Install the clamp with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



2. INSTALL NO. 2 FRONT EXHAUST PIPE SUB-ASSEMBLY


    A107610
  1. Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    40 mm (1.57 in.)

    If the length is less than the minimum, replace the compression spring.

  1. Install the No. 2 front pipe to the pipe support.



    A099436E04
  1. Install a new gasket to the No. 2 front exhaust pipe.

    HINT:
    Using a plastic-faced hammer, uniformly strike the gasket so that the gasket and No. 2 front exhaust pipe are properly fit.

    NOTICE:
    1. Be careful with the installation direction of the gasket.
    1. Do not reuse the gasket.
    1. To ensure a proper seal, do not use the front pipe to force the gasket onto the No. 2 front exhaust pipe.

  1. Install the No. 2 front pipe with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



3. INSTALL CENTER EXHAUST PIPE ASSEMBLY
  1. Install the center pipe to the 3 pipe supports.

  1. Install a new gasket and the center pipe to the No. 2 front pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



4. INSTALL TAILPIPE ASSEMBLY
  1. Install the tailpipe to the pipe support.

  1. Install a new gasket and the tailpipe to the center pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }