DRIVE BELT > ON-VEHICLE INSPECTION |
| 1. CHECK DRIVE BELT TENSION |
![]() |
Visually check the belt for cracks, oiliness or wear. Check that the belt does not touch the bottom of the pulley groove.
If necessary, replace the belt.
![]() |
Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 7.5 to 9.5 mm (0.30 to 0.37 in.) |
| Used belt | 9.0 to 13 mm (0.35 to 0.51 in.) |
Using a belt tension gauge, check the drive belt tension.
| Item | Specified Condition |
| New belt | 441 to 539 N (45 to 55) kgf |
| Used belt | 245 to 343 N (25 to 35) kgf |
![]() |
Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 11 to 15 mm (0.43 to 0.59 in.) |
| Used belt | 15 to 20 mm (0.59 to 0.79 in.) |
Using a belt tension gauge, check the drive belt tension.
| Item | Specified Condition |
| New belt | 372 to 608 N (38 to 62 kgf) |
| Used belt | 196 to 392 N (20 to 40 kgf) |
![]() |
Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 7.0 to 10 mm (0.28 to 0.39 in.) |
| Used belt | 10 to 14 mm (0.39 to 0.55 in.) |
Using a belt tension gauge, check the drive belt tension.
| Item | Specified Condition |
| New belt | 441 to 539 N (45 to 55 kgf) |
| Used belt | 196 to 343 N (20 to 35 kgf) |