Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (w/ Rear Differential Lock)

DTC    C1248/48    Open Circuit in Rear Differential Lock

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C1248/48
With vehicle speed is 50 km/h (30 mph) or more, rear differential lock switch changes from OFF to ON 3 seconds or more have passed
  1. Transfer indicator switch (rear differential lock)
  2. Skid control ECU
  3. Wire harness

WIRING DIAGRAM


F100584E01


INSPECTION PROCEDURE

1.INSPECT TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)


    F052057E03
  1. Measure the resistance of the switch.

Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pushed
Below 1 Ω
1 - 2
Not pushed
10 kΩ or higher



NG
REPLACE TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)
OK


2.CHECK WIRE HARNESS (TRANSFER INDICATOR SWITCH - SKID CONTROL ECU AND BODY GROUND)


    C123166E01
  1. Disconnect the S2 ECU connector.

  1. Disconnect the T27 switch connector.

  1. Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection
Tester Connection
T27-2 - S22-22 (EXI2)
Below 1 Ω
T27-2 -Body ground
10 kΩ or higher
T27-1 -Body ground
Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY