BRAKE MASTER CYLINDER (for TSAM Made LHD with ABS) > INSPECTION |
| 1. CHECK AND ADJUST BRAKE BOOSTER PUSH ROD |
![]() |
Set SST on the master cylinder, and then lower the pin until its tip slightly touches the piston.
![]() |
Turn SST upside down, and then set it on the booster.
Measure the clearance between the booster push rod and pin head (SST).
![]() |
To adjust the clearance of the rod, first depress the pedal so that the rod protrudes. Then fix the rod in place using SST and rotate the hexagon cap nut to adjust the clearance.