Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIATOR BRACKET SUB-ASSEMBLY


    A120273
  1. Remove the 4 bolts and 2 brackets.



2. REMOVE RADIATOR DRAIN COCK PLUG
  1. Remove the drain cock plug.

  1. Remove the O-ring.



3. ASSEMBLE SST


    A113337E01
  1. Install the claw to part A of the overhaul handle as shown in the illustration.

    SST
    09230-01010  

  1. While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

    Dimension B:
    0.2 to 0.3 mm (0.008 to 0.012 in.)



4. UNCAULK LOCK PLATE


    A113338E01
  1. Using SST, squeeze the handle until stopped by the stopper bolt to release the caulking. SST

    SST
    09230-01010  



5. REMOVE RADIATOR TANK UPPER AND RADIATOR TANK LOWER


    A099699E01
  1. Lightly tap the bracket of the radiator (or the connection area for the radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.

  1. Remove the O-ring.



6. REMOVE OIL COOLER ASSEMBLY (for Automatic Transmission)


A099700E01
  1. Remove the 2 cooler pipes.

  1. Remove the 2 nuts, 2 plate washers and oil cooler.

  1. Remove the 2 O-rings from the oil cooler.