FUEL INJECTION PUMP > ON-VEHICLE INSPECTION |
| 1. CHECK INJECTION PUMP |
![]() |
Inspect the engine speed sensor.
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 (NE-) - 2 (NE+) | 20°C (68°F) | 205 to 255 Ω |
![]() |
Inspect the spill control valve.
Measure the resistance of the spill control valve.
| Tester Connection | Condition | Specified Condition |
| 1 (SPV-) - 2 (SPV+) | 20°C (68°F) | 1 to 2 Ω |
| 2. CHECK TIMING CONTROL VALVE |
![]() |
Inspect the timing control valve.
Measure the resistance of the timing control valve.
| Tester Connection | Condition | Specified Condition |
| 1 (+B) - 2 (TCV) | 20°C (68°F) | 10 to 14 Ω |
Inspect the timing control valve operation.
Connect the battery's positive (+) lead to the timing control terminal +B.
Connect the battery's negative (-) lead to the timing control valve terminal TCV.
Check that the solenoid makes a "click" sound.