Home › ENGINE ยท 5L-E › FUEL › FUEL INJECTION NOZZLE

FUEL INJECTION NOZZLE > REASSEMBLY

for Preparation Click here



1. INSTALL NOZZLE RETAINING NUT


    FU01353E02
  1. Install the pressure pin, distance piece and nozzle assembly to the nozzle retaining nut.

  1. Install the washer to the nozzle holder, and temporarily tighten the nozzle holder to the nozzle retaining nut.

  1. Using SST, tighten the nozzle retaining nut.

    SST
    09268-64010   (09268-64020, 09268-64030)

    Torque:
    47 N*m{ 475 kgf*cm , 34 ft.*lbf }

    NOTICE:
    Over torquing could cause nozzle deformation and needle adhesion or other defects.

  1. Inspect the holder and nozzle set.



2. INSTALL RING PACKING SETTING NUT
  1. Install a new washer and ring packing setting nut.