Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > DISASSEMBLY

for Preparation Click here



1. LOOSEN GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator assembly in a vise between aluminum plates.

    NOTICE:
    Do not damage the generator.



    A157686E01
  1. Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

    SST
    09820-63020  



    A157689E01
  1. Hold SST in place, rotate the 8 mm bi-hexagon wrench clockwise, and loosen the generator pulley with clutch.

    SST
    09820-63020  



2. REMOVE GENERATOR REAR END COVER


    A117269
  1. Remove the 2 terminal covers by turning them counterclockwise.



    A117270
  1. Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

  1. Remove the screw and end cover.



3. REMOVE GENERATOR REGULATOR SUB-ASSEMBLY WITH BRUSH


    A117271
  1. Remove the 3 screws and regulator.



4. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER


    A117272
  1. Remove the 4 screws.



    A117273
  1. Using a screwdriver, pry out the stator.



5. REMOVE FITTING RING


A117274


6. REMOVE GENERATOR ROTOR ASSEMBLY

NOTICE:
Do not drop the generator rotor assembly.

  1. Remove the generator pulley with clutch.



    A117276
  1. Using a press, press out the rotor and spacer ring.