Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY

NOTICE:
Do not drop the generator rotor assembly.



    A196960E01
  1. Set the spacer ring, drive end frame, generator rotor assembly and SST1 to SST2 as shown in the illustration.

    SST
    09285-76010  
    09630-00014   (09631-00061)

  1. Using SST1, SST2 and a press, slowly press the generator rotor into the drive end frame and spacer ring.

  1. Temporarily install the generator pulley with clutch to the rotor shaft by hand.



2. INSTALL FITTING RING


    A121959
  1. Align the 3 cutouts of the fitting ring with the stator generator with rectifier.



3. INSTALL GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER
  1. Align the key of the drive end frame with the keyway of the generator stator.



    A117272
  1. Install the stator with the 4 bolts.

    Torque:
    4.3 N*m{ 44 kgf*cm , 38 in.*lbf }



4. INSTALL GENERATOR REGULATOR SUB-ASSEMBLY WITH BRUSH


    A121957
  1. Attach the brushes and terminals to the rectifier end frame of the regulator.



  1. Install the regulator with the 3 screws.


    A121958E01

    Torque:
    2.2 N*m{ 22 kgf*cm , 19 in.*lbf } for screw A
    1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B

    HINT:
    Install screw B to the position shown in the illustration.



5. INSTALL GENERATOR REAR END COVER


    A117270E01
  1. Install the rear end cover with the 2 nuts and screw.

    NOTICE:
    The Protective tower must be attached on the end cover.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
    12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf } for screw



    A117269
  1. Install the 2 terminal covers by turning them clockwise.



6. TIGHTEN GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator assembly in a vise between aluminum plates.



    A157686E01
  1. Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

    SST
    09820-30010  



    A157689E01
  1. Hold SST in place, rotate the 8 mm bi-hexagon wrench counterclockwise, and tighten the generator pulley with clutch.

    SST
    09820-30010  

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }